Sparco SB Prime 107
Solvent-based epoxy primer
SPARCO SB PRIMER 107 is a two-part epoxy solvent-based, low viscosity that reacts with the hardener to form a long-lasting coating. It is the ideal choice for use as a primer to concrete and mineral surfaces.
Technical details
- Uses
- SPARCO SB Prime 107 is recommended for the various applications:; Primer or surfacing onto prepared concrete surface, pavements, ramps, walkways, loading bay and industrial floors.; Primer onto existing concrete; Primer onto mineral substrate.
- Features
- Ready to use packing ensure correct mixing and ease of application within designed pot life which allows efficient work progress.; Especially suitable for highly absorbent substrates.; Excellent adhesion to mechanically cleaned surfaces.; Excellent impact and chemical resistant coatings.; Suitable for use in unventilated area.
- Surface preparation
- Substrate must be dry, sound, clean, and free from oil, grease, loose material, surface contaminants and other bond-inhibiting materials.; Concrete substrates must be prepared mechanically by ball blasting, milling or diamond grinding.; Weak concrete must be removed and surface defects such as blowholes and voids must be fully exposed.; Any imperfections such as cracks, holes, and gouges should…
- Coverage
- It is recommended to apply SPARCO SB PRIME 107 at a rate of 5-6 m2 / litre / coat; minimum 2 coats for normal or dense concrete. Coverage may vary slightly depending on the surface porosity of the substrate and surface conditions.
- Packaging
- Product Packaging SPARCO SB PRIME 107 Part A 10 litres/ Part B 10 litres (per set).
- Safety
- PRECAUTION After hardening thoroughly, SPARCO SB PRIME 107 is physiologically harmless. Keep the resin and hardener away from the eyes, mouth and skin. Do not breathe in the vapours. The uncured mixture can cause irritation of the skin. For best protection, wear rubber or plastic gloves. In case of contaminant, wipe away resin or hardener immediately from skin using paper towels and then wash…
- Limitations
- Minimum substrate temperature 5 °C Maximum permissible moisture content of concrete substrate 5% Minimum temperature for mixing +10 °C min. Minimum temperature for curing +10 °C min. / +35 °C max. Minimum adhesion strength of pre-treated substrate >1.5N/ mm2 Consumption: It is recommended to apply SPARCO SB PRIME 107 at a rate of 5-6 m2 / litre / coat; minimum 2 coats for normal or dense…
From the Technical Data Sheet. Confirm the full specification with our technical team before application.
Suitable For
Related Products
EcoTough Floor Primer
Water-based acrylic floor primer
EcoTough Floor primer is an eco-friendly, one component Water based primer, sealer and bonding agent prior for application of Eco Tough Floor Topcoat. Primer can be broadcasted with filler for subsequent application of EcoTough Floor Topcoat for an Anti-Slip Finish.
EcoTough Floor Topcoat
Water-based aliphatic urethane coating (two-component)
EcoTough Floor is an eco-friendly, two component high strength coating that can be enhanced with recycled glass for an Anti-Slip finish. It features a low VOC, low odour while demonstrating outstanding durability, and the ability to withstand high UV conditions. It is being crosslinked with an aliphatic crosslinker, which allows for excellent adhesion to concrete and mineral substrates that have been mechanically prepared. It exhibits low dirt pickup, good wet hiding, and long-lasting finishes.
Epoxy SF Bonding Primer #104
Epoxy-based bonding primer
Bonding primer classified in the manufacturer's Safety Data Sheet as an epoxy-based system. A full technical data sheet is available on request via the enquiry form.
Ask our technical team about Sparco SB Prime 107
Get a recommendation, coverage estimate or site-specific advice from Sparco's technical team.